Category: Windows / PDA

License: Shareware$97.00 to purchase

Limitations :

OS: SH3/ARM/ARM2002/MIPS/XScale

Size: 0.35 MB (358,766 bytes)

Introduction: Defines how to cut rectangular pieces from glass, ceramic, metal, drywall or wood stocks with minimal waste of material. The most of cutting tasks have to be done on construction sites where you should figure out how to cut pieces in fast-paced environment. GNCutter takes complete care about cutting tasks and makes you life much easier. It generates and displays complex layouts and cutting instructions right at your jobsite in less than a second! There are two cutting methods available: Nesting and Guillotine. Guillotine method implies all cuts are made from one side of sheet completely to another side, as in case of glass or ceramic cutting. Nesting method does not impose any restrictions of how cuts are made and usually produces better results than guillotine. There are two types of stock: rectangular sheets or coils (rolls) with infinite length. GNCutter detects how many sheets or how much coil length you need to order from your supplier to cut all required pieces from.